Exfo ETS-1000 Manuel d'utilisateur télécharger pdf (Page 37)

Setting up your Unit

Ethernet Tester Analyzer 29

Unit Setup

Event Log

Event log provides events messages display in the ETS-1000. Setup Log

menu and also in console terminal by connection to the device via

USB-interface and by remote control via TELNET protocol.

Logged events are listed below:

 start/stop of the test;

 Loopback mode is switched on/off;

 change of connection state;

 remote test is running;

 device is switched on/off;

 low battery.

If one of these events occurred, the following message will be displayed in

the console terminal/Log menu.

For example, if you switch on Loopback mode at the 2nd layer on port B,

the following message will be displayed:

By default the function of messages displaying via USB interface and via

TELNET protocol is switched off. To switch on/off use log on/off remote

control command.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 172 173

Pas de commentaire

Exfo ETS-1000 Manuel d'utilisateur Page 37