Exfo ETS-1000 Manuel d'utilisateur télécharger pdf (Page 86)

Configuring and Starting a Test

78 ETS-1000

OAM

 Mode: Select Mode for OAM configuring. The available OAM states are:

 Active: In active mode, the selected port can send commands to

locate remote unit, to enable the Loopback mode on the remote

unit, and to respond to the Ethernet OAM commands from the

remote unit.

 Passive: In passive mode, the port can only respond to the

Ethernet OAM commands from the remote unit, but cannot initiate

the Loopback mode.

 Off: OAM disabled.

 Discovery: Select the state of locating the remote unit. Available states

are:

 Fault

 Send local

 Passive wait

 Send loc/rem

 Send loc/rem ok

 Send any

 Remote unit: Press to switch to the Remote unit screen.

 MAC address: MAC-address of a remote unit

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 172 173

Pas de commentaire

Exfo ETS-1000 Manuel d'utilisateur Page 86