Exfo FIP-400 Fiber Inspection Probe and ConnectorMax Manuel d'utilisateur télécharger pdf (Page 37)

Setting up Your Fiber Inspection Probe and ConnectorMax

Fiber Inspection Probe 31

Reverting to Factory Settings

To transfer test configurations from one unit or computer to

another:

1. Using Windows Explorer, on the unit where the custom configurations

are located, select which files you want to transfer. The files are

located in different folders depending on the unit you are using.

 In Windows XP on a computer, or on an FTB-500 platform:

C:\Documents and Settings\All Users\Application

Data\EXFO\ConnectorMax\Test configuration files\Custom.

 In Windows Vista or 7 on a computer: C:\ProgramData\Exfo\

ConnectorMax\Test configuration files\Custom.

 On an FTB-1 or FTB-200 v2 unit: D:\Documents and Settings\All

Users\Application Data\EXFO\ConnectorMax\Test configuration

files\Custom.

2. If the two units are linked through a network and that you have access,

you can paste the files directly into the corresponding folder of the

destination unit. Otherwise, copy the files onto a USB key, then paste

the files in the destination folder once you have.

Reverting to Factory Settings

At any time in the application, you can revert to factory settings in your

menus. However, the Restore Factory Settings button is valid only for the

window or tab where you use it.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 77 78

Pas de commentaire

Exfo FIP-400 Fiber Inspection Probe and ConnectorMax Manuel d'utilisateur Page 37