Exfo FVA-3150 Variable Attenuator Manuel d'utilisateur télécharger pdf (Page 47)

Operating Your Variable Attenuator

Variable Attenuator 41

Performing an Attenuation Routine

9. Press ENTER. The first digit will start flashing. Use the up/down arrows

to change the flashing digit and the left/right arrows to activate the next

digit.

10. Once the number of steps is set, press ENTER.

11. Press the right arrow. To set the attenuation difference between the

steps.

12. Press ENTER. The first segment will start flashing. Use the up/down

arrows to change the flashing digit and the left/right arrows to activate

the next digit.

Note: Entering a negative value will increase the attenuation (in absolute value)

during the routine. Entering a positive value will decrease it.

13. Once the step size is set, press ENTER.

Note: The difference with the current attenuation must be of at least 0.002 dB for

the new attenuation step size to be valid.

14. Press the Program button to exit the menu.

Note: The initial attenuation state counts as a step.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 114 115

Pas de commentaire

Exfo FVA-3150 Variable Attenuator Manuel d'utilisateur Page 47