Exfo BV10 Performance Endpoint Unit Manuel d'utilisateur télécharger pdf (Page 45)

BV10-100 and BV10-1000 39

7 CLI Command Reference

This chapter describes the BV10 command line interface (CLI). The

commands are grouped under Operation and Configuration commands.

Note: When the BV10 is used in a BrixWorx environment, you must use BrixWorx

GUI rather than CLI prompt to manage the BV10 device. When you change

a reflector to run or not through the CLI, this is not updated on the BrixWorx

GUI Additional Services page. The GUI changes override the changes done

using the CLI prompt.

Note: Refer to Introducing the BV10 CLI on page 29 for more information on CLI

and its features.

Conventions

The following table lists the conventions used in this chapter to represent

command syntax.

Command Availability

All CLI commands can be sent through the LAN and CONSOLE ports. Only

a subset of commands can be sent through the Test port.

Convention Description Example

Pipe symbol | Choice between two

or more parameters.

all | lan | test

Select one of the keywords:

all, lan or test.

Square brackets [ ] Optional parameters.

[timeout value_in_ms]

The timeout parameter and its

value

value_in_ms are optional.

Italics Variable information.

size size_in_bytes

Enter a number in place of

size_in_bytes.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 115 116

Pas de commentaire

Exfo BV10 Performance Endpoint Unit Manuel d'utilisateur Page 45