Exfo EXpert VoIP Test Tools Manuel d'utilisateur télécharger pdf (Page 21)

Selecting and Starting a Test

EXpert IP 15

SCCP

The SCCP (Skinny Client Control Protocol) service active test measures the

performance of calls between two endpoints and a SCCP peer endpoint

made through the Cisco Call Manager.

In the SCCP test, the Controller acts as a calling endpoint (Caller), and the

Responder acts as an answering endpoint (Callee). Both endpoints must

be registered in the CallManager. Devices registered in the CallManager are

assigned a telephone number associated with the MAC address of the

device.

Note: Each endpoint executing a test against a given CallManager must have a

unique MAC address-phone number pair for that CallManager.

Note: The Caller and the Callee must be manually registered with the

CallManager with respect to their phone type before you configure the test.

For executing the call successfully, the Callee’s phone number must be a

valid number from the CallManager’s registration tables, and it should be

associated with the Responder’s MAC address.

To select, configure, and start a SCCP Test:

1. From the Main Menu, tap SCCP.

2. From the Interface tab, configure the test interface parameters. See

Interface on page 20. Ensure that the link is up in the status bar before

proceeding to the next step.

3. From the Configuration tab, configure the SCCP test. See

Configuration (SCCP) on page 32.

4. From the Parameters tab, configure the call, phone, and media

parameters. See Parameters (SCCP) on page 48.

5. From the Threshold tab, enable and configure the threshold values.

See Threshold on page 52.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 106 107

Pas de commentaire

Exfo EXpert VoIP Test Tools Manuel d'utilisateur Page 21