Exfo IQS-12002B Calibration System Manuel d'utilisateur télécharger pdf (Page 15)

Calibration System 11

2 Getting Started with Your

Calibration System

Inserting and Removing Test Modules

To insert a module into the controller or expansion unit:

1. Exit IQS Manager and turn off all your units.

2. Remove the protective cover from the desired unused module slot.

2a. Pull the retaining screw knob firmly towards you and release the

bottom of the cover.

2b. Gently pull the top of the protective cover downwards, to remove

it from the unit grooves.

3. Position the module so that its front panel is facing you and the top and

bottom protruding edges are to your right.

CAUTION

Never insert or remove a module while the controller unit and its

expansion units are turned on. This will result in immediate and

irreparable damage to both the module and unit.

Retaining screw

knob

Protective cover

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 107 108

Pas de commentaire

Exfo IQS-12002B Calibration System Manuel d'utilisateur Page 15