Exfo FIP-400B Fiber Inspection Probe and ConnectorMax2 Manuel d'utilisateur télécharger pdf (Page 23)

Setting up Your Fiber Inspection Probe and ConnectorMax2

Fiber Inspection Probe 17

Setting up Autonaming

4c. Enter the start, stop and increment values as desired.

Note: The identifiers are processed in order, from the one with the largest

indentation to the one with the smallest. For a given identifier, when the

increment value reaches the stop value, the incrementation automatically

switches to the next identifier. The order of the identifiers in the increment

window (and thereby the order of increment) follows the order of the

identification window.

Note: An identifier set to None will not appear in the increment window.

Note: To decrement values, the start number must be higher than the stop

number.

4d. Tap OK to return to the Identification window.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 110 111

Pas de commentaire

Exfo FIP-400B Fiber Inspection Probe and ConnectorMax2 Manuel d'utilisateur Page 23