Exfo FIP-400B Fiber Inspection Probe and ConnectorMax2 Manuel d'utilisateur télécharger pdf (Page 54)

Inspecting Fiber Ends

48 FIP-400B

Inspecting Fiber Ends (Single Fiber and Transceiver - Fiber Receptacles)

7. Depending on the probe you are using, proceed as follows:

 If you have an FIP-420B, activate the auto centering, then adjust the

magnification level and the image focus to have the best view of

the fiber end.

 If you have an FIP-430B, activate the auto centering and the auto

focus.

For more information, see Analyzing Captures on page 64.

8. If the fiber end is dirty, remove it from the probe, clean it and

reinspect it.

9. Once you are satisfied with the inspection, when in high magnification

level, press Capture.

Press the Fiber Inspection Probe handset button.

10. Go to the next connector or close the application.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 110 111

Pas de commentaire

Exfo FIP-400B Fiber Inspection Probe and ConnectorMax2 Manuel d'utilisateur Page 54