Exfo FTB-2 Manuel d'utilisateur télécharger pdf (Page 3)

P/N: 1066920 July 2014 3/6

To install a power meter:

1. Turn off your unit.

2. Disconnect the unit from its external power source and remove the

batteries.

3. Put on a wrist (or an ankle) antistatic strap and ensure that the end of

its wire is grounded properly.

4. Place the unit vertically so that its right panel is facing you, and then

locate the protective cover that hides the power meter bay.

5. Using a screwdriver, remove the two screws of the protective cover.

Note: Keep the screws close at hand because you will need them to secure the

power meter in place later.

6. Remove the protective cover.

IMPORTANT

Do not discard the protective cover. You will need it to protect the

power meter bay if you ever send the power meter for

recalibration.

Screws holding the

protective cover in place

1 2 3 4 5 6

Pas de commentaire

Exfo FTB-2 Manuel d'utilisateur Page 3