Exfo FastReporter 2 Manuel d'utilisateur télécharger pdf (Page 280)

100

101

Viewing and Editing Measurements

270 FastReporter 2

Editing Measurement Identification Information

Modifying the Calibration Date for OTDRs

Sometimes, older OTDR models do not provide the right calibration date

required to view the data and perform your analysis. You may need to

change it.

In your OTDR result display, you can see the calibration dates for units A

and B, if there are any. You can modify the calibration date of the OTDR file;

the updated calibration date is saved in corresponding OTDR file.

The application allows you to edit the calibration date for the OTDR

measurements based on the following conditions:

 If the file direction is A->B, you can change the date of location A.

 If the file direction is B->A, you can change the date of location B.

 If the file is in OTDR Bidir format, you can change the date of both

locations A and B

Note: The application displays the date range for up to the last ten years for the

calibration date. If no date is indicated, and you want to edit the calibration

date, the application displays the date range up to the previous month.

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 395 396

Commentaires sur ces manuels

Pas de commentaire

Exfo FastReporter 2 Manuel d'utilisateur Page 280

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Exfo FastReporter 2