Exfo FTB-800 Series for FTB-1 Manuel d'utilisateur télécharger pdf (Page 417)

100

101

Test Functions

NetBlazer 407

Filters and Packet Capture - Filters

Assign to Capture

Note: Only available when the ETH-CAPTURE software option is enabled. Refer

to Software Option on page 32 for more information.

Assigns the selected filter for packet capture. See Filters and Packet

Capture - Packet Capture on page 410.

Filter Configuration

Note: Multiple filter criteria is only available when the ADV-FILTERS option is

enabled; otherwise only one criterion is possible. Refer to Software Option

on page 32 for more information.

The filter configuration section allows to configure the filter criteria for the

selected filter. The configuration is only possible when the Enable check

box is cleared.

 “(“ and “)“, the open and close parenthesis controls the

precedence of operands when more than two operands are used.

Only one level of parenthesis is supported. When no parenthesis

are used, a logical AND has precedence over a logical OR.

 Not check box when selected, adds the logical negation (not

equal) operator for the operand filter defined at its right.

1 2 ... 412 413 414 415 416 417 418 419 420 421 422 ... 620 621

Commentaires sur ces manuels

Pas de commentaire

Exfo FTB-800 Series for FTB-1 Manuel d'utilisateur Page 417

Commentaires sur ces manuels

Produits connexes et manuels pour Instruments de mesure Exfo FTB-800 Series for FTB-1