Exfo MaxTester MAX-610 Manuel d'utilisateur télécharger pdf (Page 124)

Multimeter Tests

116 MAX-610

Capacitance/Opens

Note: The accuracy of the 2 Terminal Capacitance Measurement is impacted by

the use of the FED, and the 3 Terminal method is recommended to be used

instead.

 Selected Pair allows you to select All Pairs or a single wire pair for

measurement.

 Cable Parameters:

 Cable Type allows you to select a cable entry (with its associated

parameters) from the current Cable Book, to use for testing. The

selection is not saved when leaving the test. The current Cable

Book entry is shown by default.

 Capacitance T-R displays the capacitance value from Tip to Ring in

nF/mi ranging from 10.0 to 500.0.

 Capacitance T/R to GND displays the capacitance value from Tip

or Ring to Ground, in nF/mi ranging from 10.0 to 500.0.

 Threshold Settings button opens a new page that allows you to set the

capacitance/opens threshold for the test.

 Result displays a snapshot of the pass/fail status, Capacitance and

Length for each selected wire pair. Capacitive Balance is shown in %

when All Pairs is selected.

 Test Status displays the current state of measurement or an error

message.

To select the parameter values:

1. Press the up/down arrow keys to highlight the desired parameter.

2. Press the left/right arrow keys to view and select the options.

3. Press on a value to open a list box of options and use the navigation

keys to scroll through.

4. Press to confirm the value.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 280 281

Pas de commentaire

Exfo MaxTester MAX-610 Manuel d'utilisateur Page 124