Exfo MaxTester MAX-610 Manuel d'utilisateur télécharger pdf (Page 84)

Setting Up Copper Tests

76 MAX-610

FED Setup

Note: For all FED States other than Pass Through/Exchange Connect, the

Dialer tab is disabled. If the dialer is already running before the test starts,

the dialer will be stopped on entry of the test with a message saying Dialer

cannot be used, hence dialer will be stopped. - similar to FaultMapper

test.

 FED Factory Default button allows you to restore the factory defaults

for the following:

 Single Test defaults sets the default FED state values for all the

individual tests, except Auto Test.

 User Auto Test defaults sets the default FED state values for Auto

Test.

 All these options sets the default FED state values for all tests.

To select the parameter values:

1. Press the up/down arrow keys to highlight the desired parameter.

2. Press the left/right arrow keys to view and select the options.

3. Press on a value to open a list box of options and press the

up/down arrow keys to highlight the desired parameter.

4. Press to confirm the value.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 280 281

Pas de commentaire

Exfo MaxTester MAX-610 Manuel d'utilisateur Page 84