Exfo VDSL2 Manuel d'utilisateur Page 129

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 275
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 128
Wideband Tests
Copper, VDSL2, ADSL2+ and IP Triple-Play Test Set 121
Send Tone (TX)
Send Tone (TX)
The wideband Send Tone (TX) test
allows you to configure and transmit a
tone to a downstream device in the
loop.
Each parameter and button on the
pane is described below.
³ Frequency (kHz) is the frequency
of the transmitting tone. Specify a
value between 20 and 30000.
³ Level (dBm) is the tone level. Specify a value between -10 and 10.
³ Termination Impedance defines the impedance of the dummy load
connected to the line. Select either 100 or 135 Ohms.
³ Apply is used to confirm any changes to parameter values.
To start/stop test:
1. Press the up/down arrow keys to highlight the desired test parameter.
2. Press to select the value.
3. Press the left arrow key to erase the existing value, and then use the
alphanumeric keypad to enter a value. To cancel the entry, press .
4. Press to accept the value.
5. Change other parameter values as required.
6. Press the right arrow key, then use the up/down arrow key to highlight
the Apply button. Press to confirm any changes.
7. Press to start/stop the test.
Test results are displayed on the screen as they are completed.
Vue de la page 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 274 275

Commentaires sur ces manuels

Pas de commentaire