Exfo VDSL2 Manuel d'utilisateur Page 187

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 275
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 186
Configure Tests for DSL/IP Triple-Play Verification
Copper, VDSL2, ADSL2+ and IP Triple-Play Test Set 179
Configure DSL/IP Tests
STB Support
The STB Support tab allows you to specify the network addresses for up to
four set-top boxes to be emulated. This pane is active only for bridged
access mode.
The available parameters are the
following:
³ Number of STB is the quantity of
set top boxes (maximum 4) to be
emulated by the unit at the testing
location.
³ Obtain STB IP is either Dynamic
where the access concentrator or
broadband remote access server
assigns a temporary IP address to the set top box, or Static where you
enter the IP address of the set top box.
³ STB Vendor ID is the name of the set top box, maximum
80 characters. This entry is unavailable if Obtain STB IP is set to Static.
³ MAC1-4 is the MAC address for each specified set top box.
³ IP1-4 is the IP address for each set top box that has been specified.
To select the STB support parameters to configure:
1. Press the up/down, left/right arrows to select the desired parameter.
2. Press to open the list or modify the parameter.
3. In the list, press the up/down arrows to select the function or mode.
OR
Use the alphanumeric keypad to enter the value you want to specify.
4. Press to confirm the selection.
Vue de la page 186
1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 274 275

Commentaires sur ces manuels

Pas de commentaire